• Home
• About
• Control Panel

Remote names (#ACCRN01)

Last updated:		Applies to:		In industries:		Of versions:		Special contents:
20010510 (Andy)		Pro, MultiUser, MultiSite, MultiView				4.X (and higher)		n/a

Gate Remote Names

Gate remote names are the names of the various remotes (gates) that get sent to StorMan from the access control system...

How to configure Remote Names

1. Select Maintenance, then Access Control Setup.
2. Within the Gate Triggers section, you will notice a field for Gate Remote Names. In this field, enter the names corresponding to the remote numbers in PTI Direct. Example: If Remote 1 is a rear lift, Remote 2 the front gate, Remote 3 does nothing and Remote 4 is a side gate, then you would enter: Rear Lift,Front Gate,,Side Gate, Note: Did you notice that two commas were used for the third remote in our example above? This is because the third remote does nothing (in our example, at least), so we can cancel it out and skip it by entering nothing for the third remote name.
3. Click OK.